H2A.Z: view from the top

Jordanka Zlatanova1, Amit Thakar

  • 1Department of Molecular Biology, University of Wyoming, Laramie, WY 82071, USA. jordanka@uwyo.edu

Related Concept Videos

Rotation of Asymmetric Top01:11

Rotation of Asymmetric Top

By definition, a spherically symmetric body has the same moment of inertia about any axis passing through its center of mass. This situation changes if there is no spherical symmetry. Since most rigid bodies are not spherically symmetric, these require special treatment.
The relationship between the angular momentum of any rigid body and its angular velocity, both of which are vectors, involves the moment of inertia. The moment of inertia is a scalar quantity only for spherically symmetric...
Methods of Obtaining Topography01:25

Methods of Obtaining Topography

Topography involves measuring and mapping land elevations, natural features, and artificial structures to create accurate representations of the terrain. Topographic surveying relies on traditional and modern methods, each with distinct advantages and limitations.Traditional Surveying Methods:Transit stadia surveys and plane table surveys were widely used traditional surveying methods. These techniques relied on instruments like theodolites and stadia rods for measuring distances and angles,...
Plotting of Topographic Maps01:29

Plotting of Topographic Maps

Topographic maps represent the Earth's surface features using contour lines, which connect points of equal elevation to create a two-dimensional representation of three-dimensional terrain. Creating a topographic map requires a systematic approach.Begin by plotting a scaled grid and marking intersections corresponding to the survey's elevation data points. Assign elevation values at these intersections to build the base map. Next, determine contour levels using a consistent contour interval,...
Cranial Bones: Lateral View01:27

Cranial Bones: Lateral View

The lateral view of the cranium is dominated by temporal, sphenoid, and ethmoid bones.
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
Elevation of Intermediate Points on Vertical Curves01:20

Elevation of Intermediate Points on Vertical Curves

Vertical curves are essential in roadway design because they provide smooth transitions between varying roadway grades. Designing vertical curves involves calculating intermediate elevations and identifying the curve's highest or lowest point, which is essential for optimal roadway performance.Intermediate elevations on a vertical curve are determined using the tangent offset method. This method considers the initial elevation at the start of the curve, the grades, and the curve's geometry. The...
Hyperbolas01:30

Hyperbolas

A hyperbola is a conic section produced when a double-napped cone is intersected by a plane at an angle steeper than the slope of the cone, such that it cuts through both nappes. This intersection yields two separate, mirror-image curves known as branches, which open away from each other along the transverse axis. The nearest points on each branch to the hyperbola’s center are termed vertices, and the distance from the center to a vertex is denoted by a. Perpendicular to the transverse axis is...