Near-isothermal conditions in the middle and lower crust induced by melt migration

Gabriela V Depine1, Christopher L Andronicos, Jason Phipps-Morgan

  • 1Department of Earth and Atmospheric Sciences, Snee Hall, Cornell University, Ithaca, New York 14853, USA. gvd2@cornell.edu

Nature
|March 7, 2008
PubMed

Related Concept Videos

Bonding in Metals02:32

Bonding in Metals

Metallic bonds are formed between two metal atoms. A simplified model to describe metallic bonding has been developed by Paul Drüde called the “Electron Sea Model”. 
57.0K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
15.7K
Isothermal Processes01:21

Isothermal Processes

A thermodynamic process that occurs at constant temperature is called an isothermal process. Heat slowly flows into the system or out of the system to maintain thermal equilibrium. Processes involving phase changes like water evaporation into steam or freezing water into ice at a constant temperature are examples of Isothermal Processes.
An ideal gas can also undergo isothermal expansion or compression.
For example, consider 1 mole of an ideal gas inside an isolated cylinder at initial volume V...
5.4K
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
670
Solid–Solid Solutions01:24

Solid–Solid Solutions

The temperature-composition phase diagram of two solids, A and B, which are immiscible in the solid phase but form miscible liquids, shows that when the temperature is low, these two exist as separate, pure solids (A and B). As the temperature increases, they transition into a single-phase liquid solution where A and B coexist. Moving from point a1 to a2 in the phase diagram, the composition changes such that solid B begins to separate from the solution, enriching the remaining liquid with A.
108
Diversity of Archaea IV01:29

Diversity of Archaea IV

Hyperthermophilic archaea are a group of extremophiles thriving at temperatures above 80°C, often in hydrothermal vents and volcanic soils where conditions surpass the boiling point of water. At such temperatures, proteins, membranes, and DNA in most organisms degrade, but hyperthermophiles have evolved remarkable adaptations to maintain stability and function.Unique Cellular FeaturesHyperthermophilic membranes are composed of a monolayer of biphytanyl tetraether lipids, which resist...
611