Related Experiment Video
Updated: Jul 6, 2026

The Preparation and Properties of Thermo-reversibly Cross-linked Rubber Via Diels-Alder Chemistry
Published on: August 25, 2016
Cleavage of the ether bond by electron impact: differences between linear ethers and tetrahydrofuran
Bogdan C Ibănescu1, Olivier May, Michael Allan
1Department of Chemistry, University of Fribourg, Chemin du Musée, 9, CH-1700 Fribourg, Switzerland.
Abstract:
Dissociative electron attachment (DEA) to diethyl ether yielded primarily the C(2)H(5)O(-) ion, with a strong Feshbach resonance band at 9.1 eV and a weaker shape resonance band at 3.89 eV. Very similar spectra were obtained for dibutyl ether, with C(4)H(9)O(-) bands at 8.0 and 3.6 eV. Some of these primary ions subsequently lost H(2) and yielded weaker signals of the C(2)H(3)O(-) and C(4)H(7)O(-) ions. In contrast, DEA to the cyclic ether tetrahydrofuran (THF) yielded mainly a fragment of mass 41, presumably deprotonated ketene, at 7.65 eV. The low-energy band was missing in THF. H(-) with two bands at 6.88 and 8.61 eV, and an ion of mass 43 (presumably deprotonated acetaldehyde) with two bands at 6.7 and 8.50 eV were also observed. We propose that in the primary DEA step the C-O bond is cleaved in both the open-chain and the cyclic ethers. In the open-chain ethers the excess energy is partitioned between the (internal and kinetic) energies of two fragments, resulting in an RO(-) ion cool enough to be observed. The CH(2)(CH(2))(3)O(-) ion resulting from cleavage of the C-O bond in THF contains the entire excess energy (more than 6 eV at an electron energy of 7.65 eV) and is too short-lived with respect to further dissociation and thermal autodetachment to be detected in a mass spectrometer. These findings imply that there could be a substantial difference between the fragmentation in the gas phase described here and fragmentation in the condensed phase where the initially formed fragments can be rapidly cooled by the environment.
Related Concept Videos
Ethers to Alkyl Halides: Acidic Cleavage
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent groups, ethers can be classified into two...
Crown Ethers
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Mass Spectrometry: Molecular Fragmentation Overview
One type of fragmentation pattern is the cleavage of a single bond in the molecular ion. The cleavage leads to a radical and a cation. The cleavage can occur at...

