[North and the business of drinking water in Tarapaca, 1875-1918]

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...

Osmolality refers to the number of solute particles per kilogram of solvent in a solution. Plasma osmolality specifically indicates the total number of solute particles per kilogram of water in blood plasma. This value reflects the body's hydration status and is tightly regulated through mechanisms controlling water intake and output. While water consumption is a conscious decision, the body has intrinsic regulatory systems to maintain fluid balance. Dehydration, a state of water deficit...

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...

The xylem of vascular plants distributes water and dissolved minerals that are taken up by the roots to the rest of the plant. The cells that transport xylem sap are dead upon maturity, and the movement of xylem sap is a passive process.

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...