The effects of trochlear groove geometry on patellofemoral joint stability--a computer model study

The effect of the variation in the femoral groove geometry on patellofemoral joint stability was studied using a two-dimensional transverse plane model with deformable articular surfaces. The femoral and patellar bony structures were modelled as rigid bodies with their profiles expressed by splines. The articular cartilage was discretized into compression springs, distributed along the femoral and patellar profiles, based on the rigid-body spring model. The medial and lateral retinacula were modelled as linear tensile springs, and the quadriceps muscles and patellar tendon as strings with known tension. The anatomical data were obtained from the transverse plane magnetic resonance images of a normal knee flexed at 20 degrees and from the literature. A dynamic analysis approach was employed to solve the governing equations of the model, i.e. three static equilibrium equations of the patella and a constraint equation for each cartilage spring, explicitly. The results of the model suggest that alteration of the sulcus angle from 139 degrees to 169 degrees causes a lateral shift and tilt of less than 3 mm and 4 degrees. This effect increased slightly with increasing total quadriceps force, however, to significantly more than 7 mm and 18 degrees respectively when the medial retinaculum was released. It was suggested that this might be the combined effect of the medial retinaculum deficiency and trochlear dysplasia that is responsible for patellar subluxation and, particularly, dislocation disorders.