Related Experiment Video
Updated: Jul 6, 2026

Sandy Soil Improvement through Microbially Induced Calcite Precipitation (MICP) by Immersion
Published on: September 12, 2019
Developmental study of a low-pH magnesium phosphate cement for environmental applications
1Department of Engineering, Cambridge University, Trumping Street, Cambridge CB2 1PZ, UK.
Abstract:
This paper presents a laboratory investigation into the development of a low-pH magnesium phosphate-based cement for use in in-situ stabilisation/solidification systems, as a more effective alternative to Portland cement. The idea is to develop a cement-based binder with a low enough pH to facilitate biodegradation in combination with stabilisation/solidification processes. Potassium dihydrogen orthophosphate was selected as the phosphate source, dead-burned magnesia as the magnesium source and boric acid as the retarder. The range of mixes were tested primarily on their pH development which was found to be in the range of 6-9.5 for a magnesia to phosphate ratio range of 1:1 to 1:5. The testing revealed a dense microstructure, high early-age strength development and low volume expansion of the developed cement. Observed fracturing of some of the cured cement samples has been related to the curing conditions and the impurities present in the magnesia. On the basis of microstructural examination, observed white crystalline deposits on cured samples are likely to be a reaction product of magnesia and potassium dihydrogen phosphate.
More Related Videos
Related Concept Videos
Introduction to Electrolytes
Role of Sodium
One...
Types of Cement II
The Phosphorus Cycle
Hydration of Cement
Carbonation Shrinkage
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction facilitates the...
Soundness of Cement

