Related Experiment Video
Updated: Jul 6, 2026

Sampling and Pretreatment of Tooth Enamel Carbonate for Stable Carbon and Oxygen Isotope Analysis
Published on: August 15, 2018
The effect of a 10% carbamide peroxide bleaching agent on the phosphate concentration of tooth enamel assessed by
Ario Santini1, Colin R Pulham, Ahmed Rajab
1The University of Edinburgh, Edinburgh, UK. ariosantini@hotmail.com
Abstract:
The study assessed changes in phosphate concentrations of surface enamel treated with a proprietary bleaching agent ('PEROXIDE') containing 10% carbamide peroxide over a 28-day period using Raman spectroscopy. Six non-carious human molar teeth (age range 12-21 years), extracted for orthodontic reasons, were used. From the enamel face of each half tooth, a near flat enamel section, approximately 2 x 2 mm, was cut, providing 12 specimens. Each specimen was treated with 10% carbamide peroxide for 8 h day(-1) for 28 consecutive days, with Raman spectra being obtained prior to bleaching and after 7, 14, 21 and 28 days. Raman spectra were acquired on a confocal LabRam 300 spectrometer fitted with an Olympus B microscope (Olympus, Middlesex, UK). The difference in the maximum peak values for phosphate group concentrations were tested using the Friedman test (non-parametric anova) and Dunn's multiple comparison test. An intense broad band at 980 cm(-1), characteristic of phosphate groupings, was always observed. At 7 and 14 days, and again at 28 days, there was a significant decrease in the phosphate group concentration compared with base-line measurements (P < 0.05) but not at 21 days (P > 0.05). Ideally, bleaching should not be continued to a point where surface enamel is lost, and the present study suggests that a regime using 10% carbamide peroxide should not extend to 7 days.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
¹³C NMR: Distortionless Enhancement by Polarization Transfer (DEPT)
Effects of EDTA on End-Point Detection Methods
In the visual method, metal-ion indicators (metallochromic dyes), which have distinct colors in their free and complex forms, are added to the mixture to signal the titration's end point. They form stable complexes with metal ions, but these complexes are weaker than the corresponding metal–EDTA complexes. As a result, EDTA...
Titration of Polyprotic Base with a Strong Acid
