Atmospheric pressure photoionization mass spectrometry of polyisobutylene derivatives

Atmospheric pressure photoionization mass spectrometric (APPI-MS) study on three types of polyisobutylene derivatives is reported. Two of the polyisobutylenes investigated were polyisobutylene with dihydroxy and diolefinic end-groups derived from aromatic moieties [dicumyl chloride, 1,4-bis(2-chloro-2-propyl)benzene], and the third contained no aromatic moieties with a monohydroxy end-group. All three polyisobutylene derivatives (PIBs) had an average molecular weight (M(n)) of approximately 2000 g/mol, with a polydispersity lower than 1.2. In the positive ion APPI mode, protonated PIB molecules were formed, but the molecular weights obtained were considerably lower than those expected, indicating fragmentation of the PIB chains. In the negative APPI mode, using solvents such as tetrahydrofuran and toluene as dopants, no signal was obtained. However, in chlorinated solvents, such as CCl(4), CHCl(3), and CH(2)Cl(2), in the presence of toluene dopant, PIB adducts with chloride ions were formed with relatively high signal intensity. In the case of CH(2)Cl(2), no dopant (toluene) was necessary to generate chlorinated adduct ions, albeit increasing the toluene concentration in the flow increased the PIB signal intensity. The effect of the toluene concentration on PIB signal intensity was studied and models that include (1) photoionization of toluene, (2) formation of chloride ions from the chlorinated solvents by dissociative electron capture, (3) formation of chlorinated adduct ions and charge recombination reactions between the toluene radical cation, (4) chloride ions, and (5) chlorinated adduct ions are proposed based on the experimental results.