Related Experiment Video
Updated: Jul 6, 2026

Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere
Published on: April 30, 2018
Temperature Dependence of Absorption in Ice at 532 nm
Abstract:
A YAG laser was used to emit nanosecond pulses of light at 532 nm at depths from 1185 to 2200 m in Antarctic ice, corresponding to temperatures increasing from 229 to 249 K. From the timing distributions of photons arriving at phototubes at distances up to 100 m and at similar depths, the scattering and absorption coefficients were measured, and the temperature dependence of absorptivity at 532 nm was determined. Despite the absorptivity being many orders of magnitude lower at 532 nm than in the near ultraviolet and near infrared, the fractional increase of absorptivity, a(-1)da/dT = 0.01 K(-1), was the same in the visible, ultraviolet, and infrared. Analysis of published data at other wavelengths shows that a(-1)da/dT is ~0.01 K(-1) from 175 nm to ~1 cm, above which it increases strongly from 1 cm to 10 m. That temperature dependence applies only in regions not close to absorption bands.
Related Concept Videos
UV–Vis Spectroscopy: Beer–Lambert Law
IR Spectrum Peak Intensity: Amount of IR-Active Bonds
Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature from...
UV–Vis Spectrum
The UV–Vis spectrum of a molecule is the plot of its absorbance versus wavelength. The plot is drawn by taking molar absorptivity (ε) or log ε on the y-axis (ordinate)...
IR Spectrum
Transmittance is defined as the ratio of the radiant power passing through a sample to that from the radiation's source. Multiplying the transmittance by 100 gives the percent transmittance (%T), which varies between 100% (no absorption) and 0% (complete...
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...

