Related Experiment Videos

Unified anomaly suppression and boundary extraction in laser radar range imagery based on a joint curve-evolution and

Haihua Feng1, William Clem Karl, David A Castañon

  • 1The MathWorks, Inc, Natick, MA 01760, USA. hfeng@mathworks.com

Related Concept Videos

Real-World Applications of Space Curves01:29

Real-World Applications of Space Curves

Modern aerospace navigation depends on the accurate prediction of motion in three-dimensional space. In defense applications, radar systems continuously track both interceptors and moving aerial targets to find whether their flight paths will result in a collision. These motions are modeled mathematically as space curves, which represent paths that change continuously with time. Each object’s position is described by a vector function that specifies its location in terms of time-dependent...
Boundary Conditions: Lossless Lines01:21

Boundary Conditions: Lossless Lines

Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Area Between Curves: Problem Solving01:28

Area Between Curves: Problem Solving

A region can be enclosed by three curves: a square root function, a reflected cube root function, and a linear function. The linear function intersects each of the other two curves, and these intersection points determine where the boundary of the enclosed region changes. Because different curves serve as the upper and lower boundaries in different parts of the graph, the area cannot be found using a single setup over the entire interval.To compute the area, the region is first divided into two...
Calibration Curves: Linear Least Squares01:20

Calibration Curves: Linear Least Squares

A calibration curve is a plot of the instrument's response against a series of known concentrations of a substance. This curve is used to set the instrument response levels, using the substance and its concentrations as standards. Alternatively, or additionally, an equation is fitted to the calibration curve plot and subsequently used to calculate the unknown concentrations of other samples reliably.
For data that follow a straight line, the standard method for fitting is the linear...
Region of Convergence of Laplace Tarnsform01:20

Region of Convergence of Laplace Tarnsform

The Region of Convergence (ROC) is a fundamental concept in signal processing and system analysis, particularly associated with the Laplace transform. The ROC represents an area in the complex plane where the Laplace transform of a given signal converges, determining the transform's applicability and utility.
Consider a decaying exponential signal that begins at a specific time. When deriving its Laplace transform, the time-domain variable is replaced with a complex variable. This substitution...