Finite element simulation of the generation and detection by air-coupled transducers of guided waves in viscoelastic...

The measured characteristics (efficiency and sensitivity) of two air-coupled transducers allow for the prediction of the absolute values of the pressure of the bulk waves generated in air and for the measurement of the pressure of the field radiated in air by guided waves propagating in a structure. With finite element software, the pressure field generated by an air-coupled transducer is simulated by introducing a right-hand side member in the Helmholtz equation, which is used for computing the propagation from the transducer to a plate. The simulated source is rotated in order to impose an angle of incidence with respect to the normal of the plate and generate the corresponding guided mode. Inside the plate, the propagation is simulated with the dynamic equations of equilibrium and a complex stiffness tensor to take into account the viscoelastic anisotropy of the material. For modeling the three-dimensional fields of the guided modes propagating in a two-dimensional non-symmetry plane, a 2.5 dimensional model is introduced. The model computes the value of the pressure field radiated in air by the plates for any guided modes and can predict the detectability of the system for a known defect in a structure. A test bed incorporating two air-coupled transducers is used to generate and receive various guided modes. Two plates made of Perspex and carbon-epoxy composite are tested. The pressure measured by the receiver at various positions is compared to the results of the model to validate it.