Centrifuges and rotors

Centrifugation is a separation technique based on differences in density or size. It is commonly used to separate solids from aqueous interferents. During centrifugation, the sample is placed in centrifugation tubes and spun at high angular velocity, which allows centrifugal force to act differentially on the different densities or masses of the components. After spinning, the supernatant liquid is decanted. Depending on the specific application, either the pellet or the supernatant is retained...

Pseudo forces, or fictitious forces, appear to act on an object in motion in a rotating frame of reference with respect to an inertial reference frame. These forces are not real forces but rather mathematical constructs and are introduced to simplify calculations in a non-inertial frame while using Newton's laws of motion. Common examples of pseudo forces include centrifugal, Coriolis, and Euler forces. These forces are essential in fields such as mechanics, astrophysics, and fluid dynamics,...

The homogenate obtained after cell lysis contains various membrane-bound organelles that can be further separated into pure fractions by subcellular fractionation. These isolates are used to study specific cellular components, analyze localized protein activity, and are even employed in diagnostics. Fractionation is typically achieved using centrifugation methods, the most common being density-gradient and differential centrifugation.
Differential Centrifugation
Differential centrifugation is...

In aerobic fermentations, oxygen is vital for microbial growth and metabolite production. Since air comprises only about 20% oxygen and the gas is poorly soluble in water—just 9 ppm at 20°C—supplying sufficient oxygen becomes a critical challenge, especially in high-demand processes like yeast growth or citric acid production. Even a fully saturated broth may offer only a few seconds of oxygen availability.To address this, sterile or scrubbed air is introduced into the fermentor via a sparger...

In the growing field of wind energy, incorporating wind turbine models into transient stability analysis is essential. Induction and synchronous machines are the primary models used, with induction machines being prevalent due to their simplicity and reliability.
Induction machines interact through the rotating magnetic field generated by the stator and the rotor. The key parameter is slip, which is the difference between synchronous speed and rotor speed relative to synchronous speed. Slip is...

An object undergoing circular motion, like a race car, is accelerating because it is changing the direction of its velocity. This centrally directed acceleration is called centripetal acceleration. This acceleration acts along the radius of the curved path (thus is also referred to as radial acceleration).
Any acceleration must be produced by some force. Therefore, any force or combination of forces can cause centripetal acceleration. A few examples include the tension in the rope on a...