Related Experiment Video
Updated: Jul 5, 2026

Substantiating Appropriate Motion Capture Techniques for the Assessment of Nordic Walking Gait and Posture in Older Adults
Published on: May 12, 2016
Effect of skiing speed on ski and pole forces in cross-country skiing
Pekka Vähäsöyrinki1, Paavo V Komi, Seppo Seppälä
1Neuromuscular Research Center, Department of Biology of Physical Activity, University of Jyväskylä, Jyväskylä, Finland. pekka.vahasoyrinki@vuokattisport.fi
Purpose:
The present study characterized pole and ski forces in classical technique cross-country skiing. Eight elite junior cross-country skiers performed diagonal skiing at 65%, 75%, 90%, and 100% of maximum speed on a stable 100-m-low uphill (2.5 degrees ).
Method:
: The ski and the pole forces (vertical (Fz) and horizontal (Fy) directions) on the right and left sides were recorded separately when the skier skied over a special custom-made force platform system placed at the end of the uphill course. The entire system consisted of four separate 20-m-long rows of 1-m-long force plates connected in series, row by row.
Results:
When the forces were averaged for the various functional phases of skiing cycle, the ski Fz during the gliding phase decreased and the braking ski Fy and Fz remained the same with higher skiing speed. During the subsequent kick phase, both ski Fy and Fz increased significantly as a function of the skiing speed. Consequently, the Fy ratio between the ski and the pole plant increased with faster skiing speed. Simultaneously measured EMGs from five different muscles showed that the abdominals had a pattern of increasing activation with increase in speed of skiing. All the other muscles, vastus lateralis (VL), rectus femoris (RF), erector spinae (ES), and medial gastrocnemius (MG), were obviously active in the preloading and the kick phases.
Conclusions:
The speed dependence of the ski and the pole force distributions in the present study are important for further understanding of the complexity of cross-country skiing. Especially relevant is to use these results as basis for studies aimed at better understanding of the propulsive force production, when more comprehensive EMG analysis is complemented with simultaneous kinematic recordings at varied slope, speed, and waxing conditions.
More Related Videos
Related Concept Videos
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
Collisions in Multiple Dimensions: Problem Solving
A small car of mass 1,200 kg traveling east at 60 km/h collides at an intersection with a truck of mass 3,000 kg traveling due north at 40 km/h. The two vehicles are locked together. What is the...
Free Body Diagrams: Examples
Force and Momentum
Pole and System Stability
Simple poles are unique roots of the denominator polynomial. Each simple pole corresponds to a distinct solution to the system's characteristic equation, typically resulting in exponential decay terms in the system's response.
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The slope...

