Analyses of cutting and aspirating properties of vitreous cutters with high-speed camera
Related Experiment Video
Updated: Jul 5, 2026
Performing Microscope-Mounted Y-Shaped Cutting Tests
Published on: January 20, 2023
Tatsuhiko Sato1, Shunji Kusaka, Yusuke Oshima
1Department of Applied Visual Science, Osaka University Medical School, Japan.
Purpose:
To investigate the cutting and aspirating properties of eight vitreous cutters under different conditions and to analyze the factors determining these properties.
Methods:
Commercially available 20-gauge (20-G), 23-G, and 25-G pneumatic vitreous cutters were evaluated. The areas of the inner tube and cutting port were measured with a microscope and 3D-CAD software. The total opening area/s of the cutting port was determined by photographing the movements of the cutter blade with a high-speed camera. The total volume of balanced salt solution aspirated/s was measured.
Results:
The inner tube areas ranged from 0.350-0.352 mm2 for the 20-G, 0.169-0.196 mm for the 23-G, and 0.128-0.129 mm2 for the 25-G cutters. The port areas ranged from 0.254 to 0.306 mm2 for the 20-G, 0.122 to 0.173 mm2 for the 23-G, and 0.066 to 0.125 mm2 for the 25-G cutters. High-speed camera analyses revealed that the total opening area was determined not only by the port area but also by the duty cycle, and that the latter varied among the cutters even under the same cutting speed. There was a positive correlation (R2 >0.88) between total opening area/s and total aspirated volume/s.
Conclusions:
Larger cutting port areas and higher duty cycles are associated with higher aspirated volumes of vitreous cutters.
