Role of photolysis frequency in enhanced selectivity and yield for controlled bond breaking in HOD

Manabendra Sarma1, Manoj K Mishra

  • 1Department of Chemistry, Indian Institute of Technology, Bombay, Powai 400076, India.

Related Concept Videos

Radical Formation: Homolysis00:54

Radical Formation: Homolysis

A bond is formed between two atoms by sharing two electrons. When this bond is broken by supplying sufficient energy, either two electrons can be taken up by one atom forming ions by the cleavage called heterolysis, or the two electrons are shared by two atoms, with one each creating radicals by the cleavage called homolysis.
Photochemical Electrocyclic Reactions: Stereochemistry01:26

Photochemical Electrocyclic Reactions: Stereochemistry

The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
IR Spectrum Peak Broadening: Hydrogen Bonding01:23

IR Spectrum Peak Broadening: Hydrogen Bonding

The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular hydrogen bonding...
Cycloaddition Reactions: MO Requirements for Photochemical Activation01:12

Cycloaddition Reactions: MO Requirements for Photochemical Activation

Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
Regioselectivity and Stereochemistry of Hydroboration02:36

Regioselectivity and Stereochemistry of Hydroboration

A significant aspect of hydroboration–oxidation is the regio- and stereochemical outcome of the reaction.
Hydroboration proceeds in a concerted fashion with the attack of borane on the π bond, giving a cyclic four-centered transition state. The –BH2 group is bonded to the less substituted carbon and –H to the more substituted carbon. The concerted nature requires the simultaneous addition of –H and –BH2 across the same face of the alkene giving syn stereochemistry.
Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control01:23

Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control

The addition of a hydrogen halide to 1,3-butadiene gives a mixture of 1,2- and 1,4-adducts. Since more substituted alkenes are more stable, the 1,4-adduct is expected to be the major product. However, the product distribution is strongly influenced by temperature; low temperature favors the 1,2-adduct, whereas the 1,4-adduct is predominant at high temperature.