Influence of calcium content of biomass-based materials on simultaneous NOx and SO2 reduction

Pyrolysis products of biomass (bio-oils) have been shown to cause a reduction in NOx emissions when used as reburn fuels in combustion systems. When these bio-oils are processed with lime, calcium is ion-exchanged and the product is called BioLime. BioLime, when introduced into a combustion chamber, pyrolyzes and produces volatile products that reduce NOx emissions through reburn mechanisms. Simultaneously, calcium reacts with SO2 to form calcium sulfate and thus reduces SO2 emissions. This paper reports the characterization of composition and pyrolysis behavior of two BioLime products and the influence of feedstock on pyrolysis products. Thermogravimetric analysis (TGA) and 13C-CP/MAS NMR techniques were used to study the composition of two biomass-based materials. The composition of the pyrolysis products of BioLime was determined in a laboratory scale flow reactor. The effect of BioLime composition on NOx and SO2 reduction performance was evaluated in a 146.5 kW pilot-scale, down fired combustor (DFC). The effect of pyrolysis gas composition on NOx reduction is discussed. The TGAweight loss curves of BioLime samples in an inert atmosphere showed two distinct peaks corresponding to the decomposition of light and heavy components of the BioLime and a third distinct peak corresponding to secondary thermal decomposition of char. The study also showed that BioLime sample with lower content of residual lignin derivatives and lower calcium content produced more volatile compounds upon pyrolysis inthe combustor and achieved higher NOx reduction (15%). Higher yields of pyrolysis gases increased the NO reduction potential of BioLime through homogeneous gas phase reactions. Calcium in BioLime samples effectively reduced SO2 emissions (60-85%). However, addition of higher calcium content to the BioLime samples also appeared to inhibit the volatile yield and thereby lowered the NOx reduction.