Related Experiment Video
Updated: Jul 4, 2026

Influence of Step-Width Manipulation on Running Biomechanics
Published on: February 28, 2025
The relationship between joint kinetic factors and the walk-run gait transition speed during human locomotion
Alan Hreljac1, Rodney T Imamura, Rafael F Escamilla
1Department of Kinesiology & Health Science, California State University, Sacramento, CA, USA.
Abstract:
The primary purpose of this project was to examine whether lower extremity joint kinetic factors are related to the walk-run gait transition during human locomotion. Following determination of the preferred transition speed (PTS), each of the 16 subjects walked down a 25-m runway, and over a floor-mounted force platform at five speeds (70, 80, 90, 100, and 110% of the PTS), and ran over the force platform at three speeds (80, 100, and 120% of the PTS) while being videotaped (240 Hz) from the right sagittal plane. Two-dimensional kinematic data were synchronized with ground reaction force data (960 Hz). After smoothing, ankle and knee joint moments and powers were calculated using standard inverse dynamics calculations. The maximum dorsiflexor moment was the only variable tested that increased as walking speed increased and then decreased when gait changed to a run at the PTS, meeting the criteria set to indicate that this variable influences the walk-run gait transition during human locomotion. This supports previous research suggesting that an important factor in changing gaits at the PTS is the prevention of undue stress in the dorsiflexor muscles.
More Related Videos
06:35Using Gold-standard Gait Analysis Methods to Assess Experience Effects on Lower-limb Mechanics During Moderate High-heeled Jogging and Running
Published on: September 14, 2017
05:52Lower-Limb Biomechanical Characteristics Associated with Unplanned Gait Termination Under Different Walking Speeds
Published on: August 25, 2020
Related Concept Videos
Factors Affecting Activity Coefficient
The activity coefficient value for an ion is close to one when the solution has almost zero ionic strength, i.e., when the solution shows close to ideal behavior. As the ionic strength of the solution increases from 0 to 0.1 mol/L, a decrease in the...
Kinematic Equations - III
Using the kinematic equations,...
Kinematic Equations - I
Kinematic Equations - II
Suppose a car merges into freeway traffic on a 200 m long ramp. If its initial velocity is 10 m/s and it accelerates at 2 m/s2, then the...
Kinetic Friction
Relative Motion Analysis - Acceleration