Related Experiment Video
Updated: Jul 4, 2026

Modeling the Effects of Hemodynamic Stress on Circulating Tumor Cells using a Syringe and Needle
Published on: April 27, 2021
Transient shear stresses on a suspension cell in turbulence
1Center for Biochemical Engineering, Duke University, Durham, NC 27706, USA.
Abstract:
A model flow field representative of Kolmogorov eddies in turbulence is proposed, and its two parameters are expressed in terms of the known bioreactor variables epsilon, the rate of turbulent power dissipation, and nu, the fluid kinematic viscosity. The trajectory through this flow field of a small sphere representing a cell is determined, and from that the time-varying local shear rate can be found. This allows calculation of the shear stress at any point on the sphere's surface as it rotates in and moves through the model eddy. The maximum shear stress imposed on the cell by the surrounding turbulence has a range of 0.5-5 dyn/cm(2), and can be estimated by 5.33rho(epsilonnu)(1/2). The shear stress has two major frequency components with ranges of 1-4 and 20-80 s(-1); the higher frequency component is estimated by 0.678(epsilon/nu)(1/2). The rotation of the direction of the shear stress vector at each point on the cell's surface is also discussed. Two ways in which external stresses might affect cell growth are proposed.
Related Concept Videos
Shearing Stress
The average shearing stress can be calculated by dividing the shear by the area of the cross-section.
Newtonian Fluid: Problem Solving
A velocity gradient forms within the fluid when a Newtonian fluid is placed between two parallel plates, with...
Navier–Stokes Equations
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
Thin-Walled Hollow Shafts

