Related Experiment Video
Updated: Jul 3, 2026

Monitoring Lung Function with Electrical Impedance Tomography in the Intensive Care Unit
Published on: September 6, 2024
Proportional assist ventilation with load-adjustable gain factors in critically ill patients: comparison with
Nektaria Xirouchaki1, Eumorfia Kondili, Katerina Vaporidi
1Intensive Care Medicine Department, University Hospital of Heraklion, Medical School, University of Crete, Heraklion, Crete, Greece.
Objectives:
It is not known if proportional assist ventilation with load-adjustable gain factors (PAV+) may be used as a mode of support in critically ill patients. The aim of this study was to examine the effectiveness of sustained use of PAV+ in critically ill patients and compare it with pressure support ventilation (PS).
Design And Setting:
Randomized study in the intensive care unit of a university hospital.
Methods:
A total of 208 critically ill patients mechanically ventilated on controlled modes for at least 36 h and meeting certain criteria were randomized to receive either PS (n = 100) or PAV+ (n = 108). Specific written algorithms were used to adjust the ventilator settings in each mode. PAV+ or PS was continued for 48 h unless the patients met pre-defined criteria either for switching to controlled modes (failure criteria) or for breathing without ventilator assistance.
Results:
Failure rate was significantly lower in PAV+ than that in PS (11.1 vs. 22.0%, P = 0.040, OR 0.443, 95% CI 0.206-0.952). The proportion of patients exhibiting major patient-ventilator dyssynchronies at least during one occasion and after adjusting the initial ventilator settings, was significantly lower in PAV+ than in PS (5.6 vs. 29.0%, P < 0.001, OR 0.1, 95% CI 0.06-0.4). The proportion of patients meeting criteria for unassisted breathing did not differ between modes.
Conclusions:
PAV+ may be used as a useful mode of support in critically ill patients. Compared to PS, PAV+ increases the probability of remaining on spontaneous breathing, while it considerably reduces the incidence of patient-ventilator asynchronies.
Related Concept Videos
Ventilatory Modes
There are three ventilatory modes: full support, partial support, and spontaneous. These are described below.
Full Support Modes
Full support modes include controlled mechanical ventilation, continuous mandatory...
Mechanical Ventilation II: Invasive Ventilation
Negative-Pressure Ventilators
Negative-pressure ventilators create a vacuum around the chest or body to draw air into the lungs, simulating breathing. This method does not require an...
Mechanical Ventilation I: Indication and Settings
Mechanical Ventilation III: Noninvasive Ventilation
Noninvasive Positive-Pressure Ventilation (NIPPV)
Factors Affecting Pulmonary Ventilation
Alveolar Surface Tension
The alveolar fluid lines the luminal surface of the alveoli and exerts a force called surface tension. This force is caused by the polar water molecules in the liquid being more strongly attracted to each...
Acute Respiratory Failure-V
Ensure that patients are monitored continuously for their response to therapy, including changes in...