Non-normal Lanczos methods for quantum scattering

Reza Rajaie Khorasani1, Randall S Dumont

  • 1Department of Chemistry, McMaster University, 1280 Main St. W. Hamilton, Ontario L8S 4M1, Canada.

Related Concept Videos

Calculation of First-Law Quantities II01:24

Calculation of First-Law Quantities II

The first law of thermodynamics establishes that the change in internal energy of a system is given by ΔU = q + w, where q is the heat exchanged, and w is the work performed. For a perfect gas, both internal energy (U) and enthalpy (H) depend solely on temperature. Consequently, for any change of state, whether reversible or irreversible, the internal energy change is determined by integrating the heat capacity at constant volume, and the enthalpy change by integrating the heat capacity at...
Quantum Numbers02:43

Quantum Numbers

It is said that the energy of an electron in an atom is quantized; that is, it can be equal only to certain specific values and can jump from one energy level to another but not transition smoothly or stay between these levels.
Gauss's Law: Planar Symmetry01:27

Gauss's Law: Planar Symmetry

A planar symmetry of charge density is obtained when charges are uniformly spread over a large flat surface. In planar symmetry, all points in a plane parallel to the plane of charge are identical with respect to the charges. Suppose the plane of the charge distribution is the xy-plane, and the electric field at a space point P with coordinates (x, y, z) is to be determined. Since the charge density is the same at all (x, y) - coordinates in the z = 0 plane, by symmetry, the electric field at P...
Boundary Conditions: Lossless Lines01:21

Boundary Conditions: Lossless Lines

Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Interference and Diffraction02:18

Interference and Diffraction

Interference is a characteristic phenomenon exhibited by waves. When two electromagnetic waves interact with their peaks and troughs coinciding, a resulting wave with enhanced amplitude is produced. This is known as constructive interference. In this case, the two waves interacting are in phase with each other.
Atomic Absorption Spectroscopy: Radiation and Light Sources01:13

Atomic Absorption Spectroscopy: Radiation and Light Sources

Atomic absorption spectroscopy (AAS) relies on the Beer-Lambert law, which requires that the radiation source emits a narrow range of wavelengths to match the absorption characteristics of the analyte atom. The primary criteria for choosing an appropriate radiation source in AAS is to provide a precise and intense emission at specific wavelengths that will allow accurate detection of the analyte.
Two common narrow-range 'line' sources used in AAS are hollow-cathode lamps (HCLs) and...