Related Experiment Video
Updated: Jul 3, 2026

Dispersion of Nanomaterials in Aqueous Media: Towards Protocol Optimization
Published on: December 25, 2017
Preparation of highly concentrated nanostructured dispersions of controlled size
Stefan Salentinig1, Anan Yaghmur, Samuel Guillot
1Institute of Chemistry, University of Graz, Heinrichstrasse 28, A-8010 Graz, Austria.
Abstract:
This article presents the use of a shearing procedure for the preparation of stable nanostructured dispersions of lipid mesophases. This new application of the shearing technique is compared with the well-established ultrasonication method for the emulsification of these mesophases in water in terms of particle size, particle size distribution and available concentration range. With a laboratory-built shear device based on a Couette cell, it was possible to produce high quantities of internally self-assembled emulsion particles of controlled size at concentrated hydrophobic phase contents (phi(o)) of up to 70 wt%. The concentration limit of 70 wt% could be reached however, the maximum attainable concentration depended on the internal structure type of the particles. The limit was thus easily attained for emulsified microemulsions (EME) as well as for the emulsified inverse hexagonal phase (H(2)), whereas it was found to be lower for emulsified discontinuous (Fd3m) and bicontinuous (Pn3m) cubic phases. Moreover, by shearing, it was possible to keep the size of the particles relatively constant when increasing phi(o), whereas the particle size significantly increased with phi(o) when ultrasonication was employed. By means of ultrasonication, the hydrodynamic radius of the particles could be tuned linearly between 85 to 180 nm as a function of phi(o) up to a maximum of 20 to 30 wt%. Below the maximum concentration limit, particles displayed a well-controlled size.
Related Concept Videos
Colloidal precipitates
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...

