Related Concept Videos

Directing and Steric Effects in Disubstituted Benzene Derivatives01:18

Directing and Steric Effects in Disubstituted Benzene Derivatives

When disubstituted benzenes undergo electrophilic substitution, the product distribution depends on the directing effect of both substituents. When the directing effects of both substituents reinforce each other, a single product is obtained. For example, bromination of p-nitrotoluene occurs ortho to the methyl group and meta to the nitro group, which is the same position, resulting in a single product. However, if the directing effects of the two groups oppose each other, the more strongly...
Electrophilic Aromatic Substitution: Chlorination and Bromination of Benzene01:15

Electrophilic Aromatic Substitution: Chlorination and Bromination of Benzene

Chlorination and bromination are important classes of electrophilic aromatic substitutions, where benzene reacts with chlorine or bromine in the presence of a Lewis acid catalyst to give halogenated substitution products. A Lewis acid such as aluminium chloride or ferric chloride catalyzes the chlorination, and ferric bromide catalyzes the bromination reactions. During the bromination of alkenes, bromine polarizes and becomes electrophilic. However, in the bromination of benzene, the bromine...
NMR Spectroscopy of Benzene Derivatives01:37

NMR Spectroscopy of Benzene Derivatives

Simple unsubstituted benzene has six aromatic protons, all chemically equivalent. Therefore, benzene exhibits only a singlet peak at δ 7.3 ppm in the 1H NMR spectrum. The observed shift is far downfield because the aromatic ring current strongly deshields the protons. Any substitution on the benzene ring makes the aromatic protons nonequivalent, and the protons split each other. The peak is, therefore, no longer a singlet and the splitting pattern and their associated coupling constants depend...
Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene01:13

Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene

Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.
Benzene to 1,4-Cyclohexadiene: Birch Reduction Mechanism01:18

Benzene to 1,4-Cyclohexadiene: Birch Reduction Mechanism

Birch reduction uses solvated electrons as reducing agents. The reaction converts benzene to 1,4-cyclohexadiene. The reaction proceeds by the transfer of a single electron to the ring to form a benzene radical anion. This anion is highly basic—it abstracts a proton from the alcohol to form a cyclohexadienyl radical. Another single electron transfer gives the cyclohexadienyl anion. A proton transfer from the alcohol forms 1,4-cyclohexadiene. Since this reduction occurs via radical anion...
Diazonium Group Substitution: –OH and –H01:19

Diazonium Group Substitution: –OH and –H

Nitrous acid, a weak acid, is prepared in situ via the reaction of sodium nitrite with a strong acid under cold conditions. This nitrous acid prepared in situ reacts with primary arylamines to form arenediazonium salts. Such reactions are known as diazotization reactions. As shown in Figure 1, the formation of arenediazonium salts begins with the decomposition of nitrous acid in an acidic solution to give nitrosonium ions.