Related Experiment Video
Updated: Jul 2, 2026

A Friction Testing-Bioreactor Device for Study of Synovial Joint Biomechanics, Mechanobiology, and Physical Regulation
Published on: June 2, 2022
Changes in pore morphology and fluid transport in compressed articular cartilage and the implications for joint
George W Greene1, Bruno Zappone, Boxin Zhao
1Materials Department, University of California at Santa Barbara, CA 93106, USA.
Abstract:
Cartilage sections were cut from the middle zone of pig knee articular cartilage and attached to substrates in two different kinds of newly designed 'pressure cells', one for fluorescence the other for NMR measurements. The fluorescence cell was filled with buffer solution containing fluorescently marked 70 kDa dextran which was allowed to diffuse into the cartilage pores. A second glass surface was then pressed down onto the thin cartilage sample under different loads (pressures), and the resulting compression (strain) and change in pore volume were measured as a function of time, simultaneously with measurements of the lateral diffusion and flow pattern of the dextran molecules using Fluorescence Recovery After Photobleaching (FRAP). Complementary experiments were made on the normal diffusion coefficients of pure electrolyte solutions (no dextran) in thicker cartilage sections with pulse-gradient NMR using a new pressure cell suitable for such measurements. Taken together our results show that the highly anisotropic structure of cartilage has a strong effect on the way fluid diffuses laterally and normally at different stages of compression. Our results also show how geometric constraints on a cartilage network and trapped high MW polymer such as HA during normal compressions are likely to affect both the normal and the lateral mobilities of polyelectrolytes and water.
More Related Videos
Related Concept Videos
Structural Joints: Synovial Joints
Knee Joint
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris group...
Structural Classification of Joints
A fibrous joint is where the adjacent bones are united by fibrous connective...
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...
Growth of Cartilage and Bone Tissue
Joints
Structural joint classifications are based on the material that makes up the joint as well as whether or not the joint contains a space between the bones. Joints are structurally classified as fibrous, cartilaginous, or synovial.
Fibrous Joints Are Immovable
The bones of a...

