Solubilization in alkanes by alcohols as reverse hydrotropes or "lipotropes"

Hydrotropes in aqueous systems do not aggregate in micelles, inhibit presence of mesophases and allow significant and progressive solubilization of "insoluble" molecules in water. It was shown that n-alcohols in alkanes develop the same properties, including the power-law for maximum solubilization of "hydrophilic" molecules. The aim of this paper is to highlight properties of reverse hydrotropes or "lipotropes" by taking n-alcohol/alkane mixtures as model systems. So as to establish a clear parallel between lipotropes and hydrotropes the same methodology used to characterize hydrotropes was applied to these systems. The solubilization of solutes insoluble in alkane, i.e. water and a hydrophilic dye in dodecane, enabled by the addition of n-alcohols ( n = 2, 3, 4 and 7) was studied. In parallel, the nonmicellar aggregation state of butan-1-ol and heptan-1-ol in dodecane was investigated by small-angle X-ray scattering. By applying the Porod's treatment the specific area of the H-bond network formed by heptan-1-ol and the area occupied by hydroxyl group in this network were determined as a function of concentration. A correlation between the aggregation of alcohols in dodecane and the solubilization was made. The disrupting of concentrated mesophases by a lipotrope was illustrated by studying the effect of adding n-alcohols to water/oil/extractant ternary systems used in liquid/liquid extraction. Under some conditions the organic phase splits up into two phases: an extractant mesophase and nearly pure oil. The amount of n-alcohols required to make the extractant mesophase disappear was determined for water/alkane/malonamide extractant systems. The influence of the chain length of the n-alcohol on the efficiency as lipotrope was also experimentally studied. The trend obtained was similar to the one observed with the solubilization experiments.