Related Experiment Video

Updated: Jun 30, 2026

Modeling the Size Spectrum for Macroinvertebrates and Fishes in Stream Ecosystems
07:41

Modeling the Size Spectrum for Macroinvertebrates and Fishes in Stream Ecosystems

Published on: July 30, 2019

A new look at relationships between size at maturity and asymptotic size

J A Stamps1, M Mangel, J A Phillips

  • 1Section of Evolution and Ecology, University of California, Davis, California 95616-8755, USA.

The American Naturalist
|September 25, 2008
PubMed

More Related Videos

Experimental Manipulation of Body Size to Estimate Morphological Scaling Relationships in Drosophila06:00

Experimental Manipulation of Body Size to Estimate Morphological Scaling Relationships in Drosophila

Published on: October 1, 2011

Midface Hypoplasia and Cranial Base Morphology in Syndromic Craniosynostosis: A Comparative Analysis Study Using a Predictive Regression Model08:03

Midface Hypoplasia and Cranial Base Morphology in Syndromic Craniosynostosis: A Comparative Analysis Study Using a Predictive Regression Model

Published on: November 4, 2025

Related Concept Videos

Modeling with Differential Equations01:25

Modeling with Differential Equations

Population dynamics can be described mathematically by considering the population size P(t) as a function of time. The rate of change of the population is then represented by the derivative of P(t). A simple assumption is that the rate of growth is proportional to the size of the population itself. This leads to an exponential growth model, where the population increases rapidly without bound. While this is a useful first approximation, it does not reflect realistic long-term...
Exponential Equations for Modeling Growth01:26

Exponential Equations for Modeling Growth

Exponential models are essential for describing rapid, multiplicative changes in natural systems, such as population growth. When a population doubles at regular intervals, the process can be modeled using a suitable base. For instance, a bacterial culture that doubles every three hours follows the model n(t)=n0⋅2t/3, where n(t) is the population at the time t.A more general model uses the natural base e, especially for continuous growth. This takes the form n(t)=n0⋅ert, where r is the relative...
Changes in the Appendicular Skeleton with Age01:09

Changes in the Appendicular Skeleton with Age

The upper and lower limb initially develops as a small bulge called a limb bud, which appears on the lateral side of the early embryo. The upper limb bud appears near the end of the fourth week of development, with the lower limb bud appearing shortly after.
Initially, the limb buds consist of a core of mesenchyme covered by a layer of ectoderm. The ectoderm at the end of the limb bud thickens to form a narrow crest called the apical ectodermal ridge. This ridge stimulates the underlying...
Population Growth00:57

Population Growth

Population size is dynamic, increasing with birth rates and immigration, and decreasing with death rates and emigration. In ideal conditions with unlimited resources, populations can increase exponentially, which plots as a J-shaped growth rate curve of population size against time. This type of curve is characteristic of newly-introduced invasive species, or populations that have suffered catastrophic declines and are rebounding.However, realistic environmental conditions limit the number of...
Stability of structures01:14

Stability of structures

In mechanical engineering, the stability of systems under various forces is critical for designing durable and efficient structures. One fundamental way to explore these concepts is by analyzing systems like two rods connected at a pivot point, O, with a torsional spring of spring constant k at the pivot point. This system is similar in appearance to a scissor jack used to change tires on a car. In this case, the arms of the linkage (equivalent to the rods in this system) are entirely vertical,...
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity01:15

Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity

Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.