Signed, sealed and delivered: "big tobacco" in Hollywood, 1927-1951

K L Lum1, J R Polansky, R K Jackler

  • 1Center for Tobacco Control Research and Education and Department of Medicine, University of California, San Francisco, California, 94143-1390, USA.

Tobacco Control
|September 27, 2008
PubMed
Abstract

Related Concept Videos

Inhaled Medications01:23

Inhaled Medications

Inhaled medications are crucial for managing chronic obstructive pulmonary disease (COPD) and asthma. They are essential for effective treatment and control, ensuring optimal respiratory health and well-being. Inhaled medication delivers drugs directly to the lungs, providing a rapid onset of action and reducing systemic side effects compared to oral or injectable medications. Three primary types of inhalation devices are used to administer these medications: nebulizers, metered-dose inhalers...
Drug Regulation01:25

Drug Regulation

Drug regulation encompasses the management of drug usage by evaluating its safety and efficacy through assessments conducted by regulatory authorities. Regrettably, the history of drug regulation is marred by several catastrophic events. One such incident is the Elixir Sulfanilamide tragedy, in which the toxic compound diethyl glycol was included in a sweet-tasting medication, leading to numerous fatalities. This event prompted the enactment of the Food, Drug, and Cosmetic Act in 1938. Under...
Vaporization01:18

Vaporization

The physical form of a substance changes by changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. For vaporization to occur, kinetic energy must be greater than the intermolecular forces that keep molecules bonded. The amount of energy needed to vaporize a quantity of liquid at a given pressure and a constant temperature is called the heat of vaporization. When...
Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
Sign Convention01:30

Sign Convention

When analyzing a beam subjected to various loads, it is crucial to understand the internal forces and moments generated within the structure. These internal forces can be broadly classified into normal forces, shear forces, and bending moments. To determine these forces and moments, we use the method of sections and apply a specific sign convention based on their direction and the side of the section being analyzed.
The normal force acts perpendicular to the beam's cross-section and can cause...
Oral Drug Delivery Systems: Introduction01:23

Oral Drug Delivery Systems: Introduction

Oral drug delivery is the most common route of administration due to its convenience, cost-effectiveness, and high patient compliance. It enables precise formulation to ensure proper drug dosage and bioavailability. The development of oral dosage forms considers drug properties such as solubility, stability, and absorption to optimize therapeutic efficacy.Tablets, capsules, liquids, and chewable formulations enhance drug stability, mask undesirable tastes, and improve patient experience.