Sulfur trace determination in petroleum products by isotope dilution ICP-MS using direct injection by thermal...

An accurate, sensitive, and fast method for direct determination of total sulfur in petroleum products after thermal vaporization of an isotope-diluted sample was developed by using ICP-MS. (34)S-labelled dibenzothiophene spike was used for the isotope dilution step. The isotope-diluted sample was injected into a thermal vaporizer which was directly connected by a heated transfer line to the plasma torch. Sample transport was achieved by using a helium gas flow, and the isotope ratio (34)S/(32)S was determined within seconds after injection. No other sample preparation other than the simple and fast isotope dilution step, which enables accurate and sensitive determination of sulfur at high sample throughputs, is necessary. Thus, this technique fits all needs for routine analyses. Validation of the TV-ICP-IDMS method was carried out by analyzing the certified gas oil reference materials BCR672 and BCR107. Comparison of results for noncertified low- and high-boiling samples, obtained from an ICP-IDMS microwave-assisted digestion method, also resulted in very good agreement. The low detection limit of 40 ng/g and the large dynamic range of TV-ICP-IDMS fulfill all necessities to allow analysis of sulfur in different petroleum products, e.g., even at the low concentration level of 'sulfur-free' gasoline.