Related Experiment Video
Updated: Jun 29, 2026

Grafting Multiwalled Carbon Nanotubes with Polystyrene to Enable Self-Assembly and Anisotropic Patchiness
Published on: April 1, 2018
Pressure- and temperature-induced association of arborescent polystyrene-graft-poly(ethylene oxide) copolymers at the
Gabriel N Njikang1, Lan Cao, Mario Gauthier
1Department of Chemistry, Institute for Polymer Research, University of Waterloo, Ontario, Canada.
Abstract:
The influence of surface pressure and subphase temperature on the association of arborescent polystyrene- graft-poly(ethylene oxide) (PS- g-PEO) copolymers at the air-water interface was investigated using the Langmuir balance and atomic force microscopy (AFM) techniques. These dendritic molecules form stable condensed monolayers with surface compressional moduli >250 mN/m. The variation in film thickness observed as a function of surface pressure suggests that at low surface pressures (gaslike phase) the PEO chains remain adsorbed at the air-water interface. At higher surface pressures (condensed phase), the PEO chains partially desorb into the subphase and adopt a more brushlike conformation. Large islandlike clusters with a broad size distribution were observed for samples with PEO contents of up to 15% by weight. In contrast, copolymers with PEO contents of 22-43% displayed enhanced side-by-side association into ribbonlike superstructures upon compression. The same effect was observed even in the absence of compression when the subphase temperature was increased from 12 to 27 degrees C. The temperature-induced association was attributed to increased van der Waals attractive forces between the PS cores relative to the steric repulsive forces between PEO chains in the coronas because the solvent quality for the PEO segments decreased at higher temperatures. The restricted number of superstructures observed for arborescent copolymers as compared with linear- and star-branched PS-PEO block copolymers is attributed to the enhanced structural rigidity of the molecules due to branching.
More Related Videos
09:22Self-assembling Morphologies Obtained from Helical Polycarbodiimide Copolymers and Their Triazole Derivatives
Published on: February 7, 2017
07:01Preparation of Hollow Polystyrene Particles and Microcapsules by Radical Polymerization of Janus Droplets Consisting of Hydrocarbon and Fluorocarbon Oils
Published on: January 25, 2018
Related Concept Videos
Polymer Classification: Architecture
Molecular Weight of Step-Growth Polymers
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
Free-Radical Chain Reaction and Polymerization of Alkenes
Types of Step-Growth Polymers: Polyesters
Polyesters are commonly prepared from terephthalic acid and ethylene glycol; the crude product is known as poly(ethylene terephthalate) or PET. However, polyesters are synthesized industrially by transesterification of dimethyl terephthalate with ethylene glycol at 150 °C. The two reactants and the polymer...
Characteristics and Nomenclature of Copolymers
Radical Chain-Growth Polymerization: Chain Branching