Reducing contrast makes speeds in a video-based driving simulator harder to discriminate as well as making them

Mark S Horswill1, Annaliese M Plooy

  • 1School of Psychology, University of Queensland, St Lucia, Brisbane, QLD 4072, Australia. m.horswill@psy.uq.edu.au

Perception
|October 16, 2008
PubMed

Related Concept Videos

Introduction to Limits01:30

Introduction to Limits

A limit describes the value a function approaches as its input moves closer to a particular point. Even when a function is undefined at a specific value, limits allow us to analyze its behavior near that point. This concept is fundamental in calculus and essential for understanding continuity, derivatives, and integrals.Mathematically, a function f(x) has a limit L at x = a if its values L approach x as x gets arbitrarily close to a. This is written as:This notation expresses that the function...
Downsampling01:20

Downsampling

When considering a sampled sequence with zero values between sampling instants, one can replace it by taking every N-th value of the sequence. At these integer multiples of N, the original and sampled sequences coincide. This process, known as decimation, involves extracting every N-th sample from a sequence, thereby creating a more efficient sequence.
The Fourier transform of the decimated sequence reveals a combination of scaled and shifted versions of the original spectrum. This...
Decreasing Function01:27

Decreasing Function

A decreasing function describes a relationship where the output consistently declines as the input increases. This means that for any two input values, if one is greater than the other, the corresponding output is smaller. Mathematically, a function f is decreasing on an interval I if for every x1 < x2​ in I, f (x1) > f (x2). This type of behavior is visually identified on a graph that slopes downward from left to right.The nature of a function can be analyzed by calculating its rate of...
Aliasing01:18

Aliasing

Accurate signal sampling and reconstruction are crucial in various signal-processing applications. A time-domain signal's spectrum can be revealed using its Fourier transform. When this signal is sampled at a specific frequency, it results in multiple scaled replicas of the original spectrum in the frequency domain. The spacing of these replicas is determined by the sampling frequency.
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...