Empirical corrections to density functional theory highlight the importance of nonbonded intramolecular interactions

Matthew D Wodrich1, Daniel F Jana, Paul von Ragué Schleyer

  • 1Laboratory for Computational Molecular Design, Institut des Sciences et Ingenierie Chimiques, Ecole Polytechnique Federale de Lausanne, CH-1015 Lausanne, Switzerland.

Related Concept Videos

Structure and Bonding of Alkenes02:47

Structure and Bonding of Alkenes

Olefins, which are unsaturated hydrocarbons containing one or more carbon–carbon double bonds, are broadly divided into alkenes and cycloalkenes. The general chemical formula of an alkene is CnH2n.
Doubly bonded carbons are sp2 hybridized and have a trigonal planar geometry. The double bond is composed of a σ bond formed by the overlap of hybrid orbitals and a π bond produced by the lateral overlap of unhybridized 2p orbitals on both the carbons. Each carbon atom is bonded to two hydrogen atoms...
Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation04:01

Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation

Thus far, the ideal gas law, PV = nRT, has been applied to a variety of different types of problems, ranging from reaction stoichiometry and empirical and molecular formula problems to determining the density and molar mass of a gas. However, the behavior of a gas is often non-ideal, meaning that the observed relationships between its pressure, volume, and temperature are not accurately described by the gas laws.
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified petroleum gas (LPG), fuel oil, gasoline, diesel fuel, and...
The Van der Waals Equation01:26

The Van der Waals Equation

The ideal gas law is based on two simplifying assumptions: first, that there are no intermolecular attractions between gas molecules, and second, that the volume occupied by the molecules themselves is negligible compared with the volume of the container. However, these assumptions don't hold up under all conditions - specifically, at high pressures and low temperatures, as gas tends to deviate from ideal gas behavior.The van der Waals equation is an enhanced version of the ideal gas law,...
Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...