Apparent Specific Volume Measurements of Poly(ethylene oxide), Poly(butylene oxide), Poly(propylene oxide), and...

Apparent specific densities of aqueous solutions of the diblock copolymers C18(EO)100, C18(EO)20, and (EO)92(BO)18 and the triblock copolymers (EO)25(PO)40(EO)25 and (EO)21(PO)47(EO)21 in the micellar state have been measured over a temperature range from 10 to 90 degrees C at concentrations between 1% and 5%, using an oscillating tube densitometer. From these measurements, apparent specific volumes of poly(ethylene oxide) (PEO), poly(propylene oxide) (PPO), poly(butylene oxide) (PBO), and octadecane in the micellar state have been determined. The composition of the block copolymers was checked by NMR spectroscopy. Results were compared with published data for the polymers and bulk values for octadecane, respectively. The apparent specific density of PEO chains in the dissolved state was also measured for PEG4600 solutions at different concentrations and compared with results in the micellar state. The results presented in the paper are crucial in connection with analysis and modeling of small-angle X-ray scattering (SAXS) data from polymer and block copolymer micellar systems. PEO and PPO have a relatively low apparent partial specific volume in water at low temperatures. It is associated with water molecules making strong hydrogen bonds with the oxygen atoms on the polymer backbone. These water molecules gradually become disordered when the temperature is increased and the polymer apparent specific volume increases. For PBO in the micellar cores of PBO-PEO block copolymer micelles and in PNiPAM microgels, pronounced temperature dependence with the same origin is also found. The application of the derived results for the apparent specific volume of PEO for deriving contrast factors is demonstrated and the results are used in the analysis of SAXS data for semidilute solutions of PEG4600 in a broad temperature range.