Related Experiment Video
Updated: Jun 28, 2026

09:31
Calcium Carbonate Formation in the Presence of Biopolymeric Additives
Published on: May 14, 2019
Homogeneous nucleation of calcium hydroxide
Talanta
|February 1, 1968
Abstract:
The rate of nucleation of calcium hydroxide in carefully purified supersaturated solution was observed to be about 10(3) particles, cm(-3). sec(-1), in solutions with activity products a(ca)a(OH)(2) around 4 x 10(-5). These data correspond to a homogeneous nucleus containing about 55Ca(OH)(2) units, and a nucleus-solution interfacial tension of 65 erg cm (2).
Related Concept Videos
Factors Affecting Solubility
Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:
Hydration of Cement
Hydration of cement is a chemical reaction between cement particles and water. This process occurs primarily through two mechanisms: through-solution and topochemical. In the through-solution process, anhydrous compounds dissolve into their constituents, hydrates form in the solution, and then precipitate from the supersaturated solution. The topochemical process involves solid-state reactions at the cement particle surface. The through-solution process dominates the topochemical process at the...
Qualitative Analysis
For solutions containing mixtures of different cations, the identity of each cation can be determined by qualitative analysis. This technique involves a series of selective precipitations with different chemical reagents, each reaction producing a characteristic precipitate for a specific group of cations. Metal ions within a group are further separated by varying the pH, heating the mixture to redissolve a precipitate, or adding other reagents to form complex ions.
For instance, group IV...
For instance, group IV...
Ionic Compounds: Formulas and Nomenclature
An element composed of atoms that readily lose electrons (a metal) can react with an element composed of atoms that readily gain electrons (a nonmetal) to produce ions through complete electron transfer. The compound formed by this transfer is stabilized by the electrostatic attractions (ionic bonds) between the oppositely charged ions.
Ionic Strength: Effects on Chemical Equilibria
The addition of an inert ionic compound increases the solubility of a sparingly soluble salt. For example, adding potassium nitrate to a saturated solution of calcium sulfate significantly enhances the solubility of calcium sulfate. Le Châtelier's principle cannot predict this shift in the equilibrium. Instead, this could be explained in terms of changes in the effective concentration of the ions in solution in the presence of added inert salt.
In this solution, the primary cation—the calcium...
In this solution, the primary cation—the calcium...
Precipitation Processes
The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...

