Related Experiment Video
Updated: Jun 28, 2026

Activating Molecules, Ions, and Solid Particles with Acoustic Cavitation
Published on: April 11, 2014
Ultraviolet spectra of metal ions in 6M hydrochloric acid
L Goodkin1, M D Seymour, J S Fritz
1Ames Laboratory, USAEC and Department of Chemistry Iowa State University, Ames, Iowa 50010, U.S.A.
Abstract:
Ultraviolet absorption spectra of 66 metal ions in aqueous 6M hydrochloric acid were recorded and the spectra of 36 metal ions that absorb appreciably are reported. The absorption of these metal ions is sufficient to permit their detection in liquid chromatography.
More Related Videos
07:44Determining the Chemical Composition of Corrosion Inhibitor/Metal Interfaces with XPS: Minimizing Post Immersion Oxidation
Published on: March 15, 2017
11:04Ion Mobility-Mass Spectrometry Techniques for Determining the Structure and Mechanisms of Metal Ion Recognition and Redox Activity of Metal Binding Oligopeptides
Published on: September 7, 2019
Related Concept Videos
Ions as Acids and Bases
Salts are ionic compounds composed of cations and anions, either of which may be capable of undergoing an acid or base ionization reaction with water. Aqueous salt solutions, therefore, may be acidic, basic, or neutral, depending on the relative acid-base strengths of the salt’s constituent ions. For example, dissolving the ammonium chloride in water results in its dissociation, as described by the equation:
Standard Electrode Potentials
Qualitative Analysis
For instance, group IV...
Polyprotic Acids
IR and UV–Vis Spectroscopy of Carboxylic Acids
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency, 1710 cm−1. The C=O bond of the...
Titration of a Weak Base with a Strong Acid
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...