Related Experiment Video
Updated: Jun 28, 2026

Qualitative Identification of Carboxylic Acids, Boronic Acids, and Amines Using Cruciform Fluorophores
Published on: August 19, 2013
Determination of carboxylic acid vapour by a thickness-sheer-mode acoustic wave sensor coated with crown ethers
1College of Chemistry and Chemical Engineering, Hunan University, Changsha, 410082, People's Republic of China.
Abstract:
The frequency response sensitivities for 39 organic vapours by thickness-sheer-mode (TSM) acoustic wave sensors coated with monobenzo-15-crown-5 (B15C5), monobenzo-18-crown-6 (B18C6) and dibenzo-30-crown-10 (DB30C10) have been reported. It shows that crown ethers are the most efficient adsorptively active material for sensing carboxylic acid vapour, particularly B15C5 can be used for sensing formic acid vapour. The B15C5 based sensor possesses good reproducibility, high stability and short response time with wide linear detection range and a low detection limit down to 0.0201 mg l(-1) (about 5.70 ppm, V/V) of formic acid vapour while coating with 12 mug of B15C5. There is no significant interference from other organic vapours except for some nitrogen containing compounds such as diethylamine, pyridine and N,N-dimethylformamide, and carboxylic acid homologues such as acetic and propionic acids. The effect of humidity is easily controllable. Compared with acid-base titration method, the sensor can be used for the determination of HCOOH vapour with recovery rate of 98.4 approximately 103.8%, the analytical results are in good agreement with those obtained by the more time consuming acid-base titration method.
More Related Videos
Related Concept Videos
IR and UV–Vis Spectroscopy of Carboxylic Acids
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency, 1710 cm−1. The C=O bond of the...
Spectroscopy of Carboxylic Acid Derivatives
In the...
NMR and Mass Spectroscopy of Carboxylic Acids
While α protons of carboxylic acids absorb at 2–2.5 ppm, β protons absorb further upfield.
Carboxylic acids are easily identified by dissolving them in deuterium oxide, which results in a rapid exchange of the acidic protons with deuterium. This leads to the disappearance of the acidic...
Crown Ethers
Physical Properties of Carboxylic Acid Derivatives
Among the carboxylic acid derivatives, the boiling points of acid chlorides and esters are very similar and are the lowest in the series. Acid anhydrides have slightly higher boiling...
Physical Properties of Carboxylic Acids

