Unusual results are those that have a very low chance of occurring. Unusual results can be identified using probabilities and the range rule of thumb. In problems involving probability, unusual results can be observed in 2 instances – an unusually high number of successes or an unusually low number of successes.
According to the range rule of thumb, any value above or below two standard deviations, 2σ  from the mean, μ  is considered unusual.
Maximum unusual value = μ + 2σ
Minimum unusual value...

An even signal, whether in continuous-time or discrete-time, is defined by its symmetry with its time-reversed version. Mathematically, this is represented as

One-Way ANOVA can be performed on three or more samples with equal or unequal sample sizes. When one-way ANOVA is performed on two datasets with samples of equal sizes, it can be easily observed that the computed F statistic is highly sensitive to the sample mean.
Different sample means can result in different values for the variance estimate: variance between samples. This is because the variance between samples is calculated as the product of the sample size and the variance between the...

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...

One-way ANOVA can be performed on three or more samples of unequal sizes. However, calculations get complicated when sample sizes are not always the same. So, while performing ANOVA with unequal samples size, the following equation is used:

The goodness–of–fit test can be used to decide whether a population fits a given distribution, but it will not suffice to decide whether two populations follow the same unknown distribution. A different test, called the test for homogeneity, can be used to conclude whether two populations have the same distribution. To calculate the test statistic for a test for homogeneity, follow the same procedure as with the test of independence. The hypotheses for the test for homogeneity can be stated as...