Determination of ortho-phthalaldehyde in air and on surfaces

Three sampling and analytical methods have been developed and evaluated for ortho-phthalaldehyde (OPA): (1) an HPLC-UV method for OPA in air, (2) a fluorimetric method for OPA on surfaces, and (3) a colorimetric method for OPA on surfaces. (1) The air sampler contains 350 mg of silica gel coated with 1 mg of acidified 2,4-dinitrophenylhydrazine (DNPH). Air sampling may be conducted at 0.03 to 1.0 L min(-1) for periods up to 8 h. Samples were eluted with ethyl acetate, and the eluents were allowed to stand for 72 h. Analysis was by high performance liquid chromatography (HPLC) with a UV detector set at 369 nm. An unusual phenomenon was the observation that the stability of the sample on a sampler at 3 degrees C tends to decrease as the total quantity of OPA collected on the sampler decreases. Elution of the samples within 24 h of air sampling is required. The detection limit (LOD) is approximately 0.02 microg of OPA per sample. OPA on surfaces may be collected with strips cut from a sheet of polyvinyl alcohol (PVA wipe). (2) In the surface wipe method with analysis by fluorescence measurement, the strips of PVA wipe were placed into dimethyl sulfoxide. An aliquot was treated with aqueous N-acetyl-l-cysteine and ethylenediamine. Analysis was performed with a portable fluorometer (excitation and emission wavelengths = 365 nm and 438 nm, respectively). The LOD is 0.2 microg per sample. (3) In the surface wipe method with visual colorimetric detection, the strips of PVA wipe were placed into 30 : 70 acetonitrile : water. An aliquot was treated with N-(1-naphthyl)ethylenediamine in 0.1 m sulfuric acid. After color development, the LOD is approximately 48 microg per sample. These methods have been field tested in a hospital.