Monastic charitable provision in Tudor England: quantifying and qualifying poor relief in the early sixteenth century

The first law of thermodynamics establishes that the change in internal energy of a system is given by ΔU = q + w, where q is the heat exchanged, and w is the work performed. For a perfect gas, both internal energy (U) and enthalpy (H) depend solely on temperature. Consequently, for any change of state, whether reversible or irreversible, the internal energy change is determined by integrating the heat capacity at constant volume, and the enthalpy change by integrating the heat capacity at...

Thermodynamic systems undergoing phase transitions or temperature changes experience energy transfer in the form of heat (q) and work (w). For a reversible phase change at constant temperature (T) and pressure (p), the process involves no chemical reaction but results in energy exchange between distinct phases.The heat transferred during this process corresponds to the latent heat of transition, which is the amount of heat energy absorbed or released by a substance when it changes from one...

Altruistic behaviors are “unselfish” behaviors—those that help another individual at the expense of the individual carrying out the behavior. Despite the negative consequences for the altruistic animal, these behaviors are thought to have evolved for several reasons.

Voluntary behavior with the intent to help other people is called prosocial behavior. Why do people help other people? Is personal benefit such as feeling good about oneself the only reason people help one another?

In any system of units, the units for some physical quantities must be specified through a measurement process. These measurements are the base quantities of the system, and their units are the base units of the system. The algebraic combinations of the base values can then be used to express all other physical quantities. Each of these physical quantities is then referred to as a derived quantity, with each unit being referred to as a derived unit.
The International Organization for...

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
Data measured using an ordinal scale are similar to nominal scale data, but there is one major difference. The ordinal scale data can be ordered. An example of ordinal scale data is a list of the top five national parks in the...