Photoelectrochemical water splitting using dense and aligned TiO2 nanorod arrays

Dense and aligned TiO2 nanorod arrays are fabricated using oblique-angle deposition on indium tin oxide (ITO) conducting substrates. The TiO2 nanorods are measured to be 800-1100 nm in length and 45-400 nm in width with an anatase crystal phase. Coverage of the ITO is extremely high with 25 x 10(6) mm(-2) of the TiO2 nanorods. The first use of these dense TiO2 nanorod arrays as working electrodes in photoelectrochemical (PEC) cells used for the generation of hydrogen by water splitting is demonstrated. A number of experimental techniques including UV/Vis absorption spectroscopy, X-ray diffraction, high-resolution scanning electron microscopy, energy-dispersive X-ray spectroscopy, and photoelectrochemistry are used to characterize their structural, optical, and electronic properties. Both UV/Vis and incident-photon-to-current-efficiency measurements show their photoresponse in the visible is limited but with a marked increase around approximately 400 nm. Mott-Schottky measurements give a flat-band potential (V(FB)) of +0.20 V, a carrier density of 4.5 x 10(17) cm(-3), and a space-charge layer of 99 nm. Overall water splitting is observed with an applied overpotential at 1.0 V (versus Ag/AgCl) with a photo-to-hydrogen efficiency of 0.1%. The results suggest that these dense and aligned one-dimensional TiO2 nanostructures are promising for hydrogen generation from water splitting based on PEC cells.