Partial rupture of a locked patch of the Sumatra megathrust during the 2007 earthquake sequence

A Ozgun Konca1, Jean-Philippe Avouac, Anthony Sladen

  • 1Tectonics Observatory, Division of Geological and Planetary Sciences, California Institute of Technology, Pasadena, California 91125, USA.

Nature
|December 5, 2008
PubMed

Related Concept Videos

Long-patch Base Excision Repair01:02

Long-patch Base Excision Repair

Since the discovery of the two BER pathways, there has been a debate about how a cell chooses one pathway over the other and the factors determining this selection. Numerous in vitro experiments have pointed out multiple determinants for the sub-pathway selection. These are:
Destabilization of Microtubules01:45

Destabilization of Microtubules

The destabilization of microtubules can occur during different stages of the microtubule lifecycle, such as nucleation or elongation. It can take place at either end of the microtubule or in the microtubule lattices as a whole. The lifespan of individual microtubules within a cell varies according to the cell type and stage of the cell cycle. During interphase, the lifespan of the microtubule is about 30 minutes, while during cell division, it is about 15 minutes. In axonal microtubules of...
Stress-Strain Diagram - Brittle Materials01:24

Stress-Strain Diagram - Brittle Materials

Brittle materials, including glass, cast iron, and stone, exhibit unique characteristics. They fracture without considerable change in their elongation rate, indicating that their breaking and ultimate strength are equivalent. Such materials also show lower strain levels at the point of rupture. The failure in brittle materials predominantly results from normal stresses, as evidenced by the rupture created along a surface perpendicular to the applied load. These materials do not display...
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Microcracking in Concrete01:20

Microcracking in Concrete

Microcracking in concrete refers to the tiny cracks that can form within the material even before any external load is applied. These microcracks typically occur at the interface between the coarse aggregate and the hydrated cement paste, often as a result of differential volume changes prompted by variations in stress-strain behavior, as well as thermal and moisture movement. Initially, these microcracks remain stable and do not grow substantially until the concrete is stressed to about 30...
Aneurysm III: Interprofessional Care01:26

Aneurysm III: Interprofessional Care

Aneurysm management involves either conservative medical therapy or surgical intervention, depending on the size and symptoms of the aneurysm. Conservative management is generally reserved for smaller, asymptomatic aneurysms, while larger or symptomatic aneurysms often necessitate surgical repair.Conservative Medical TherapyFor small, asymptomatic aneurysms, particularly abdominal aortic aneurysms (AAA) less than 5.5 centimeters in diameter, conservative medical therapy is recommended. This...