Thermo-responsive hydrogels based on acryloyl-L-proline methyl ester and their use as long-acting testosterone...

New thermo-responsive hydrogels were synthesized by copolymerizing acryloyl-L-proline methyl ester (A-ProOMe) with minor amounts of 2-hydroxypropyl methacrylate (HPMA) or polyethylene glycol 600 dimethacrylate (14G), using gamma-rays from a 60Co source. In water, extensive swelling of the hydrogels occurred at 10 degrees C, but there was marked deswelling as the temperature was raised to 37 degrees C. The poly(A-ProOMe-co-HPMA) hydrogel was characterized by an initial rapid shrinkage at the surface in the deswollen state; this shrinkage arose because of the formation of a rigid membrane barrier devoid of micropores. The system is therefore 'surface regulated'. In contrast, no such a barrier formed in the deswollen poly(A-ProOMe-co-14G) hydrogel. The whole matrix shrunk without the disappearance of micropores, and it is therefore a 'matrix pumping' system. Testosterone was incorporated into both these types of hydrogels, and the drug-loaded hydrogels were implanted subcutaneously into the backs of castrated rats. The daily dose of testosterone released in vivo from the poly(A-ProOMe-co-HPMA) hydrogel was constant at approximately 30 micrograms/day throughout an experimental period of 54 weeks. In contrast, drug release from the poly(A-ProOME-co-14G) hydrogel reached a maximum after one week and then decreased linearly with time down to the 7th week, when it was undetectable. These conclusions were supported by the changes in weight of the ventral prostates and right-side seminal vesicles of the rats, which were restored to normal when delivery of the testosterone was sustained.