Determination of surface tilt angle of splay and bend liquid crystal cells

A surface is called orientable if a consistent choice of unit normal vector can be made at every point on the surface. A thin soap film stretched across a wire loop provides a familiar example. The film separates the air on one side from the air on the other, so one side can be selected as positive and the opposite side as negative. Once this choice is made, a unit normal vector can be assigned smoothly across the entire surface.At each point on the soap film, a unit normal vector points...

When a solid is dipped inside a liquid, the liquid surface becomes curved near the contact. For some solid–liquid interfaces, the liquid is pulled up along the solid, while for others, the liquid surface is convex or depressed near the solid surface. This phenomenon can be explained using the concept of cohesive and adhesive forces.
The adhesive force is the molecular force between molecules of different materials, that is, between the molecules of the solid and the liquid. The cohesive force...

Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal centroidal axes. The...