Related Experiment Video
Updated: Jun 26, 2026

Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
Published on: November 22, 2019
Synchronously pumped continuous-wave mode-locked yellow Raman laser at 559 nm
Eduardo Granados1, Helen M Pask, David J Spence
1MQ Photonics, Department of Physics, Macquarie University, NSW 2109, Australia. granados@ics.mq.edu.au
Abstract:
We demonstrate the operation of a continuous-wave (CW) picosecond yellow laser operating at 559 nm. A solid-state Raman laser using a KGW crystal was synchronously pumped by an 80 MHz laser operating at 532 nm. The output pulses were compressed from 10 ps at 532 nm down to 3.2 ps at 559 nm, strongly depending on the cavity length detuning. Slope efficiencies up to 42% were observed when the system was optimized for maximum output power. This technique can be extended to a range of visible wavelengths between 550-600 nm by using different Raman materials, and by cascaded conversion.
Related Concept Videos
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...

