Related Experiment Video
Updated: Jun 26, 2026

Utilization of Microscale Silicon Cantilevers to Assess Cellular Contractile Function In Vitro
Published on: October 3, 2014
Size effects in mechanical deformation and fracture of cantilevered silicon nanowires
Michael J Gordon1, Thierry Baron, Florian Dhalluin
1Department of Chemical Engineering, University of California, Santa Barbara, California 93106-5080, USA. mjgordon@engr.ucsb.edu
Abstract:
Elastic modulus and fracture strength of vertically aligned Si [111] nanowires (ø = 100-700 nm) in an as-grown state have been measured using a new, multipoint bending protocol in an atomic force microscope. All wires showed linear elastic behavior, spring constants which scale with (length)(3), and brittle failure at the wire-substrate junction. The "effective" Young's modulus increased slightly (100 --> 160-180 GPa) as wire diameter decreased, but fracture strength increased by 2-3 orders of magnitude (MPa --> GPa). These results indicate that vapor-liquid-solid grown wires are relatively free of extended volume defects and that fracture strength is likely controlled by twinning and interfacial effects at the wire foot. Small wires (100 nm) grown with a colloidal catalyst were the best performers with high modulus ( approximately 180 GPa) and fracture stress >1 GPa.
Related Concept Videos
Temperature Dependent Deformation
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Plastic Deformations
Impact Loading on a Cantilever Beam
When an object is dropped onto the free end of a cantilever, its potential energy due to gravity is...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...

