Heat-induced whey protein gels: protein-protein interactions and functional properties

Heat-induced gelation (80 degrees C for 30 min or 85 degrees C for 60 min) of whey protein concentrate (WPC) solutions was studied using small deformation dynamic rheology, small and large deformation compression, and polyacrylamide gel electrophoresis (PAGE). The WPC solutions (15% w/w, pH 6.9) were prepared by dispersing WPC powder in water (control), 1% (w/w) sodium dodecyl sulfate (SDS) solution, and N-ethylmaleimide (NEM) solution at a protein/NEM molar ratio of 1:1 or in 10 mM dithiothreitol (DTT) solution. PAGE analyses showed that the heat treatment of control solutions contained both disulfide and non-covalent linkages between denatured protein molecules. Only disulfide linkages were formed in heated SDS-WPC solutions, whereas only non-covalent linkages were formed in DTT-WPC and NEM-WPC solutions during heating. In heated NEM-WPC solutions, the pre-existing disulfide linkages remained unaltered. Small deformation rheology measurements showed that the storage modulus (G') values, compared with those of the control WPC gels (approximately 14000 Pa), were 3 times less for the SDS-WPC gels (approximately 4000 Pa), double for the NEM-WPC gels (approximately 24000 Pa), and even higher for the DTT-WPC gels (approximately 30000 Pa). Compression tests suggested that the rubberiness (fracture strain) of the WPC gels increased as the degree of disulfide linkages within the gels increased, whereas the stiffness (modulus) of the gels increased as the degree of non-covalent associations among the denatured protein molecules increased.