Related Experiment Video
Updated: Jun 25, 2026

Determining The Electromyographic Fatigue Threshold Following a Single Visit Exercise Test
Published on: July 27, 2015
Interpretation of EMG integral or RMS and estimates of "neuromuscular efficiency" can be misleading in fatiguing
Todor I Arabadzhiev1, Vladimir G Dimitrov, Nonna A Dimitrova
1Centre of Biomedical Engineering, Bulgarian Academy of Sciences, Sofia, Bulgaria. tosho@clbme.bas.bg
Abstract:
In occupational and sports physiology, reduction of neuromuscular efficiency (NME) and elevation of amplitude characteristics, such as root mean square (RMS) or integral of surface electromyographic (EMG) signals detected during fatiguing submaximal contraction are often related to changes in neural drive. However, there is data showing changes in the EMG integral (I(EMG)) and RMS due to peripheral factors. Causes for these changes are not fully understood. On the basis of computer simulation, we demonstrate that lengthening of intracellular action potential (IAP) profile typical for fatiguing contraction could affect EMG amplitude characteristics stronger than alteration in neural drive (central factors) defined by number of active motor units (MUs) and their firing rates. Thus, relation of these EMG amplitude characteristics only to central mechanisms can be misleading. It was also found that to discriminate between changes in RMS or I(EMG) due to alterations in neural drive from changes due to alterations in peripheral factors it is better to normalize RMS of EMG signals to the RMS of M-wave. In massive muscles, such normalization is more appropriate than normalization to either peak-to-peak amplitude or area of M-wave proposed in literature.

