Related Experiment Video
Updated: Jun 25, 2026

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Early-age characteristics of red mud-coal gangue cementitious material
Na Zhang1, Henghu Sun, Xiaoming Liu
1State Key Lab of New Ceramics and Fine Processing, Department of Materials Science and Engineering, Tsinghua University, Beijing, China.
Abstract:
This experimental research was to investigate the possibility of incorporating red mud and coal gangue as raw materials for the production of red mud-coal gangue cementitious material, abbreviated as RGC, including analyses of its chemical composition, physical properties, mechanical properties and hydration products. The red mud and coal gangue (at a ratio of 3:2) were mixed together and shaped in small spheres with a water to solid ratio of 0.30 and then calcined at 600 degrees C for 2h. Subsequently, the RGC was prepared by blending 50% the resultant red mud-coal gangue mixtures, 24% blast-furnace slag, 20% clinker and 6% gypsum. The hydration products of RGC were characterized by XRD, TG-DTA and SEM-EDS. The results showed that it is feasible to use red mud and coal gangue to replace up to 50% of the raw materials to produce cementitious material, which can be called as silica-alumina based cementitious material. The hydration products of RGC are mostly ettringite, calcium hydroxide and C-S-H gel. As the dominant products, C-S-H gel and ettringite are principally responsible for the strength development of RGC in early hydration process. The content of Ca(OH)(2) initially increased but later was depleted after reaching the peak value at 21 days. Moreover, it is found that the composition of the C-S-H gel shifted towards higher Si, Al and Na contents with the increase of hydration age, whereas that of Ca shifted towards lower content.
More Related Videos
05:52Resource Recycling of Red Soil to Synthesize Fe2O3/FAU-type Zeolite Composite Material for Heavy Metal Removal
Published on: June 2, 2022
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Related Concept Videos
Porosity in Cement Paste
The balance of water to cement in the mix is critical—it...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...
Pozzolans
Fly ash is a...
Alkali Aggregate Reaction in Concrete
Hydration of Cement