Frictional resistance in plastic preadjusted brackets ligated with low-friction and conventional elastomeric...

To compare frictional resistance of the plastic preadjusted brackets ligated with the low-friction ligatures with those of the conventional elastomeric ligatures.

In vitro study.

Department of Orthodontics, Faculty of Dentistry, Kyushu University, Fukuoka, Japan.

The testing model consisted of four 0.022-inch plastic preadjusted brackets for the first premolar, the canine, the lateral incisor, and the central incisor. A superelastic nickel-titanium 0.014-inch wire and a stainless steel 0.019 x 0.025-inch wire were used for this test. The brackets were either aligned or out of line by 0.5, 1.0, 1.5 and 2.0 mm for the 0.014-inch wire and aligned for the 0.019 x 0.025-inch wire. The frictional forces in plastic preadjusted brackets with low-friction ligatures and conventional elastomeric ligatures were measured at a pulling speed of 0.1 mm/second. Welch t-tests were used to compare the mean differences of each testing measurement between the low-friction and the conventional elastomeric ligatures.

In both use of the superelastic nickel-titanium 0.014-inch wire and the stainless steel 0.019 x 0.025-inch wire, the brackets with the low-friction ligatures showed significantly lower frictional forces than those of the conventional elastomeric ligatures in both aligned and all misaligned brackets (P < 0.0001).

The study found the significantly lower frictional forces for the low-friction ligatures than those of the conventional elastomeric ligatures.