Alternative method for (64)Cu radioisotope production

The method for (64)Cu production based on a (64)Ni target using an 18MeV proton energy beam was developed. The studies on the optimisation of targetry for the 18MeV proton bombardments were performed in terms of the cost-effective target utilisation and purity of the (64)Cu product. The thickness-specific (64)Cu yield (microCi/(microA x microm)) was introduced into the optimisation calculation with respect to cost-effective target utilisation. A maximum target utilisation efficacy factor (TUE) was found for the proton energy range of 2.5-13MeV with corresponding target thickness of 36.2microm. With the optimised target thickness and proton energy range, the (64)Ni target thickness saving of 45.6% was achieved, while the overall (64)Cu yield loss is only 23.9%, compared to the use of the whole effective proton energy range of 0-18MeV with target thickness of 66.6microm. This optimisation has the advantage of reducing the target amount to a reasonable level, and therefore the cost of the expensive (64)Ni target material. The (64)Ni target electroplated on the Au-Tl multi layer coated Cu-substrate was a new and competent design for an economic production of high quality (64)Cu radioisotope using an 18MeV proton energy cyclotron or a 30MeV cyclotron with proton beam adjustable to 18MeV. In this design, the Au coating layer plays a role of protection of "cold" Cu leakage from the Cu substrate and Tl serves to depress the proton beam energy (from 18MeV to the energy optimised value 13MeV). The ion exchange chromatographic technique with a gradient elution was applied to improve the (64)Cu separation with respect to reducing the processing time and control of (64)Cu product quality.