Medium-term analysis of modern ceramic-on-ceramic bearing in THA
Silke Aldrian1, Thomas Nau, Felix Gillesberger
1Department of Orthopaedic Surgery, LKH Bad Radkersburg, Austria. silke.aldrian@meduniwien.ac.at
Abstract:
A variety of different bearing surfaces have been used to avoid osteolysis following hip replacement. We report a retrospective review of medium-term results of a modern ceramic-ceramic bearing (Biolox, CeramTec, Plochingen, Germany) and uncemented components (Alpha Cera Fit Alphanorm, Lassnitzhohe, Austria) in 107 hip arthroplasties. The clinical outcome based on serial radiographs and scoring was assessed with a minimum follow-up of 7 years (mean, 7, 6 years; range, 7, 1-8, 3 years). The average age of the patients at surgery was 64, 6 + 11, 7 years (range: 21-88 years). The mean Harris hip score was 90, 4 (range, 84, 7-99, 2). Three patients with an extra long femoral neck experienced fracture of the ceramic femoral head, resulting in cessation of use of this combination. Radiological evaluation did not reveal any signs of lysis or loosening. Massive heterotopic ossification was seen in three patients. Medium-term follow-up showed excellent clinical and radiological results. Continued follow-up will be required to determine if this ceramic-on-ceramic bearing is associated with extended survivorship.
Related Concept Videos
Bearings: Problem Solving
Pivot Bearings
A pivot bearing is a specialized type of bearing designed to support axial loads on a rotating shaft. The bearing surface, or the pivot, is positioned at the end of a shaft to support the axial thrust. The pivot may...
Journal Bearings
To better understand the concept of journal bearings, consider a rope winch with dry or...
Collar Bearings
Bearing Stress
Due to the intricacy of these microforces, an average value, known as bearing stress, is often used by...
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...
