Effect of particle spatial distribution on particle deposition in ventilation rooms

We used simulations and experimental tests to investigate indoor particle deposition during four commonly used ventilation modes, including ceiling supply, side-up supply, side-down supply and bottom supply. We used a condensation monodisperse aerosol generator to generate fine diethylhexyl sebacate (DEHS) particles of different sizes along with two optical particle counters that measured particle concentration at the exhaust opening and inside a three-dimensional ventilated test room. We then simulated particle deposition using the same ventilation modes with computational fluid dynamics (CFD) method. Our simulated results indicate that mean deposition velocity/rate for particles 0.5-10 microm (aerodynamic diameter) is not affected by different ventilation modes. However, both our experimental and simulated results indicate that the deposition loss factor, a parameter defined based on mass balance principle to reflect the influence of particle distribution on deposited particle quantity, differ significantly by ventilation mode. This indicates that ventilation plays an important role in determining particle deposition due to the apparent differences in the spatial distribution of particles. The particle loss factor during ventilation modes characterized by upward air flow in the room is smaller than that of mixing ventilation; however this trend was strongly influenced by the relative location of the inlets, outlets and aerosol source.